How to fix problems with the touch surface of Pulse?

Here are a few helpful tips if you're having trouble with the touch surface on your Soundbrenner Pulse.

First, make sure you're wearing the device - not just holding it in your hands. Our touch sensor is designed to work best when it's in contact with your skin.

Second, be sure to use two fingers when you tap, and to place them flat on the surface. Don't use just your fingertips.

If you find it difficult to start or stop the metronome or tap in the BPM, try tapping more quickly. The Soundbrenner Pulse distinguishes between a short tap and a long press.

Finally, if you're still having trouble, you can try to recalibrate the touch sensor by resetting the Soundbrenner Pulse.

To do this, hold the device around the edge - make sure you don't touch the surface - and attach the charging cable or charging station to the charging pins. If your device did not come with a charging station, you will need to locate the reset hole on the side of the device and press it with the help of a pin. 

Was this article helpful?
13 out of 17 found this helpful
Contact support

Articles in this section

See more